DRV8825 Stepper Motor Driver 2.5 A

Pack of 10 pcs

DRV8825 Stepper Motor Driver 2.5 A

Stepper motor driver DRV8825 with Micro-stepping capability.  The module has a pinout that is identical to A4988 driver, yet it affoards better performance.  Both drivers are compatible with the RAMPS shield for 3D printers and CNC.

The DRV8825 features adjustable current limiting, overcurrent, and overtemperature protection, and six microstep resolutions (down to 1/32-step). It can deliver up to approximately 1.5 A per phase without a heat sink or forced air flow (it is rated for 2.5 A per coil with sufficient additional cooling).

The driver requires a logic supply voltage (3 – 5.5 V) to be connected across the VDD and GND pins and a motor supply voltage (8 – 45 V) to be connected across VMOT and GND. The logic voltage can be supplied from an external source, such as that powering the logic of the rest of the system.

This DRV8825 stepper driver is provided with heat sink to protect the board from overheating.

You might use stepper driver extension board for easy connection of the driver with arduino and motors 

Features

• 6 different step resolutions: full-step,1/2 step, 1/4 step,1/8 step, 1/16 step and 1/32 microstepping.
• Adjustable current control lets you set the maximum current output with a potentiometer.
• Over-temperature thermal shutdown, under-voltage lockout, and crossover-current protection
• Short-to-ground and shorted-load protection